 |
 |
|
Jumper Wire
|
 |
 Specifications in PDF format - 112kb
Jumper Wire or Crossovers, as they are sometimes called, are basically interconnection devices between points on a P.C. Board. Normal reasons for use are:
- Inability to connect two points on a P.C. Board due to other circuit paths which must be crossed over.
- An After-the-Fact design change that requires new point connections.
- Circuit tuning by changing point connections.
Jumper wires offer a quick, simple, low cost solution to these problems. They are especially suited for automatic machine insertion on lead tape, or available in all packaging styles including precut and formed leads for manual insertion. Contact SPI for additional information.
| Style |
Dimensions (mm) |
| A1 |
A2 |
S |
d |
Current Rating |
| JPW-05 |
52.4 ± 1 |
26 +1/-0 |
5 ± 0.2 |
0.5 ± 0.05 |
6 A @ 70°C |
| JPW-08 |
52.4 ± 1 |
26 +1/-0 |
5 ± 0.2 |
0.6 ± 0.05 |
7.5 A @ 70°C |
| JPW-07 |
52.4 ± 1 |
26 +1/-0 |
5 ± 0.2 |
0.7 ± 0.05 |
8.5 A @ 70°C |
| JPW-08 |
52.4 ± 1 |
26 +1/-0 |
5 ± 0.2 |
0.8 ± 0.05 |
10 A @ 70°C |
 |
|
0 Ohm Resistors
|
|
Specifications in PDF format - 189kb
- Low resistance, less than 0.005O
- Ideal for automatic insertion
| Style |
Dimensions (mm) |
| L |
D |
H |
d |
| RD18 |
3.3 ± 0.4 |
1.8 ± 0.3 |
29 ± 2 |
0.48 ± 0.03 |
| RD14 |
6.3 ± 0.5 |
2.3 ± 0.3 |
28 ± 2 |
0.58 ± 0.03 |
|
 |
Carbon Film
